Manually create the Security Connector virtual machine with the hard disk image file
Before you begin
- Download Security Connector
- Confirm that the folder you extracted contains the akamai-sc-<imageID>.vhd file, where <imageID> is the ID associated with the image.
You can manually deploy the Security Connector virtual machine with the hard disk image file. These instructions apply to Microsoft Hyper-V on Windows Server 2016. These steps may vary on other versions of Windows or Windows Server.
Note: The virtual hard disk file image file that’s used to create the virtual machine is the hard disk drive for the virtual machine. Therefore, the changes you make to the virtual machine are saved to the hard disk or the image file. If you need to create a new Security Connector virtual machine, make sure you download a new image file.
- Open Hyper-V Manager.
- Select the computer or local server where you’re deploying the virtual machine.
- In the Actions menu, select .
- Review the Before You Begin content and click Next.
- In the Specify Name and Location window, enter a name for the VM and click Next.
- In the Assign Memory window, enter 2048 in the Startup Memory field and click Next.
- In the Configure Networking window, select the virtual switch that you want from the Connection menu, and click Next.
In the Connect Virtual Hard Disk window, complete these steps:
- Select Use an existing virtual hard disk option and click Browse.
- Browse to the akamai-sc-<imageID>.vhd file, where <imageID> is the ID associated with the virtual hard disk image file.
- Click Open.
- Click Next
- Review the summary with the details you selected for the VM. Click Finish.
Modify the number of virtual processors:
- Select the VM that was created in step 9 and in the Actions menu, click Settings.
- In the Hardware menu, select Processor.
- In the Number of virtual processors field, enter 2 and click Apply.
Update the network adapter settings:
- In the Hardware menu, click Add Hardware.
- Select Network Adapter and click Add.
- Select the network adapter you added.
- Select the virtual switch. Depending on your network topology, this may be the switch you added in step 7.
- Click Apply and then click OK.
Select the virtual machine and in the Actions menu, click
Start. After starting the VM, in the Actions menu,
click Connect to access the VM. It may take a few minutes
for the machine to start.
Ignore any errors that may appear while the virtual machine boots.
Create a security connector password