Configure the IoT Edge Connect behavior

Configure this behavior to enable the IoT Edge Connect product, connect previously reserved namespaces, and decide which protocols users can use to publish and receive messages. Each jurisdiction requires a separate configuration.

How to

  1. Make sure that the Enable switch is set to On.
  2. Select the namespace-jurisdiction pair from the Namespace dropdown.
  3. Enable at least one communication protocol:
    • MQTT
      Note: MQTT uses a secure connection using port 8883.
    • MQTT over WebSocket
      Note: MQTT over WebSocket uses a secure connection using port 443.
    • HTTP
      Note: HTTP uses a secure connection using port 443.